TOSEEK 1-1/8" 27.5" 3K T800 Full Carbon Fiber Rigid Disc Brake MTB Fork, 28.6mm Threadless Straight Tube Superlight Mountain Bike Front Forks

Ridiculously light and definitely puts up with a beating. I've been riding it for a few months now and not a single complaint.

I've put about 50 km on it so far and haven't needed to see a dentist, so I'd say it's pretty strong. I weigh 200 lbs, so I was a bit worried. Installed on a Genesis Bohe (Kent) gravel frame. I went with the middle size (27.5") in order to raise the front of my bike and effectively raise my stack height to get the handlebars up higher for a more comfortable riding position. The 26" size would be closer to what stock was as shown in a different review, but the 27.5" size is closer to what it would be like if I put a suspension fork on and it doesn't look too ridiculous with the extra clearance above the tire. Comes with a low-profile bearing race for the bottom headset bearing that sits real low against the crown, so what happened was I had to take the plastic dust seal out of the headset stack so that the bearings would sit flush against the races and to prevent any binding when the stack is preloaded with the compression plug. Used "Origin8 3K Weave Ahead Fusion Expander Compression Plug 1-1/8", Black" and I highly recommend it. Only one complaint. There was a bit of paint or epoxy in the threads of the disc brake caliper mount. I cleaned it out with a sacrificial bolt after I found my tap to be cutting too aggressively. Came right out then used my good bolts to torque up. The mount is aligned properly to the rotor, so no issues there like some others have said.

Bought these to replace heavy and unnecessary, to us, suspension forks on a couple of carbon MTB we also bought on Amazon a few years ago essentially making straight bar gravel bikes. Also bought one to put a disc brake wheel on a 20 year old Cannondale road bike. Got some miles on them and like them!

This fork went on a Kent Genesis Bohe gravel bike I got at Walmart. I ended up ordering all three sizes to see which one was the closest to the fork on the bike and it’s 700c wheels. The 26” was exactly the same measurements from head tube bearing to the dropouts as the factory fork. I have ridden outside several times now and it’s great. Smoother than the steel fork and 680g lighter.

The fork fit perfect and looks to be great quality. It did not include the "star nut" to connect the step cap to the fork.

turned my mtb into a monster cross commuter. Make sure to have the appropriate crown race to apply to this fork. like most new forks some light sanding to apply the crown race should do the trick. have only ridden it 10 miles but it feels great.